DV509 Diaphragm valve High-pressure valve adjustable High-pressure valve spool action Micro-shot mini valve adjustable Pinch tube valve Positive displacement screw valve controller Positive displacement screw valve for filled materials Spray valves & controller VC-1195A valve controller VD510 Diaphragm Valve VDP150 Positive Displacement Valve VMP30H Mini Poppet Valve VP300 Poppet Valve		Spray valves & controller
		SV1217 adjustable no-clog spray valve The SV1217 spray valve provides close tolerance spray dispensing of fluids up to 1000 cps, including urethanes, flux and paints. The material is fed from a pressure reservoir. Each valve is actuated by air pressure sequenced by a controller. The operating air pressure opens a needle valve allowing material to flow; a separate air line creates pressure in the air cap, atomizing the fluid. The SV1217 is adjustable by turning the stroke-adjust control at the rear of the valve; this will tune the spray pattern.
		Coating and flow rate are controlled by the fluid pressure, needle stroke, distance from the valve to the work and the duration that the valve is open SV1217 specification   Weight: 5.3oz (150gm) Operating air pressure: 70 - 100 psi (5 - 7 bar) Atomizing air pressure: 1 - 30 psi (0.1 - 2 bar) Fluid viscosity range: up to 1000 cps Fluid pressure: 1 - 100 psi (0.1 - 7 bar) - depends on material viscosity Nozzle diameter: 0.046” (1.17mm) Flow rate: up to 28cc/sec Operating frequency: over 400 cycles/min Spray angle: 28º Spray pattern: circular (conical spray) Operating air inlet: 10-32 thread with push-in fitting for 1/4 tube Atomizing air inlet: 10-32 thread with push-in fitting for 1/4 tube Material inlet: 1/8 NPT with compression fitting for 1/4 tube Model SV1217 spray valve high frequency (HF) SV1217SS spray valve HF stainless steel SV1000 spray valve low frequency SVC100-110 valve controller 110V SVC100-220 valve controller 220V CE SVC100 spray valve controller The SVC100 is a programmable spray valve controller providing the adjustment controls necessary for a clean spray application. By controlling the relationship (time) between the fluid start signal and the atomizing signal it is possible to open each independently. This feature is critical in ensuring that the fluid air line pressure momentarily starts before the atomizing pressure opens and that the atomizing pressure stays on momentarily after the fluid cuts off. This ensures adequate cleaning of the nozzle after the full spray cycle. Controller specification   External dimensions: 9.05” x 7.32” x 3.54” (230 x 186 x 90mm) Weight: 6lbs (2.73kg) Power input SVC100-110: AC 110V 50/60Hz Power input SVC100-220: AC 220V 50-60Hz Dispensing pressure: 0-6kg/cm2 Dispensing time: 0.001 sec - 99.99 sec. Dispensing selection: LCD digital display Input/output signal: Open connector, DC24V (selector by change)